fulltone ocd overdrive pedal Fulltone OCD v2 Overdrive Pedal – Gladesville Guitar Factory

fulltone ocd overdrive pedal Fulltone OCD v2 Overdrive Pedal – Gladesville Guitar FactoryThe Fulltone OCD v2 Overdrive Pedal is a modern classic for guitarists worldwide. With a redesigned output buffer, Class A input section, and switchable bypass modes, this overdrive pedal remains a go to choice for its dynamic response and maximum signal integrity. Upgrade your sound with the Fulltone OCD. The pedals you place after your overdrive pedal can influence the sound of your overdrive. The OCD has an updated output buffer that is impervious

The Fulltone OCD v2 Overdrive Pedal is a modern classic for guitarists worldwide. With a redesigned output buffer, Class A input section, and switchable bypass modes, this overdrive pedal remains a go-to choice for its dynamic response and maximum signal integrity. Upgrade your sound with the Fulltone OCD.

The pedals you place after your overdrive pedal can influence the sound of your overdrive. The OCD has an updated output buffer that is impervious to the sonic effects of successive pedals. This means that your tone remains consistent no matter where in your chain or loop switcher the OCD is placed.

The OCD has received many slight tweaks since its birth in 2004, often incorrectly identified as “version 2, Version 3, Version 4.” In reality there has always been only one version. Version 1, with very slight variations in a couple of values after that making them V1.0 through V1.8. All OCDs serial 205811 and higher are the new, less compressed versions some refer to as "v2.01"

What's stayed the same
The OCD was the first pedal to use Mosfets as clipping devices. Another first was their configuration as "hard clippers connected to v-ref" instead of to ground, as was the norm. These things contribute greatly as to why the OCD has such touch-sensitivity, why they react so well when the strings are hit hard or soft, and why they sound & feel different than all other pedals out there, 90% of which are just slight tweaks of the Tube Screamer.

NEW FEATURES:
Output buffer (when pedal is turned on in True-Bypass mode, or always when in Enhanced Bypass mode) which eliminates it from being influenced by effects that came after it. Translation, your sound remains consistent regardless of placement in today’s more complex signal-chains, loopers, and pedalboards. This buffer also had a positive effect on the sound, it reduced loading on the pedal’s hard-clipping stage, allowing more sustain of both the sound and the overtones.

Class A configured discrete 2N5457 JFET input section, raising the input impedance to 1 mega ohms (previously 330K) and increasing the dynamics…resulting in significantly better interaction with both single coil and humbuckers.

Internal switch to choose between ”Enhanced Bypass” & True-Bypass, and with no popping sound in either mode.